Company Profile

Coriolis Meter Emerson Units Micro Motion ELITE Mass Flow Measurement Guide

Quick Answer

Emerson Micro Motion ELITE meters measure mass flow, density, and temperature in one device. Typical outputs are 4-20 mA HART and Modbus RS485. Silver Automation Instruments supplies compatible Coriolis mass flow meters for DN15 to DN100 lines, often with a shorter lead time and lower cost.

What Are Emerson Micro Motion ELITE Units

This guide covers Coriolis meter Emerson units, specifically the Micro Motion ELITE series. The ELITE is a Coriolis flow meter made by Emerson. It reports mass flow in kg/h, lb/min, or t/h. It also reports density in g/cm3 or kg/m3 and process temperature in °C. A built-in PT100 RTD measures temperature at the sensor tube. Many plants use this meter for liquids, gases, and slurries because the measurement does not depend on flow profile, density changes, or fluid conductivity. It works for deionized water at 0.1 µS/cm and for hydrocarbons that magnetic flow meters cannot read.

Key Specifications of Micro Motion ELITE

Standard ELITE models cover line sizes from DN15 to DN100. Mass flow accuracy for liquids is often 0.05 percent to 0.1 percent of rate. Density accuracy is 0.0005 g/cm3. Temperature accuracy is 0.2 °C. The sensor handles process temperatures from -50 °C to 200 °C and pressures up to 100 bar on standard designs. Wetted materials include 316L stainless steel and Hastelloy C22. The transmitter offers 4-20 mA HART, pulse, and Modbus RTU. ATEX Zone 1 and IECEx approvals are common.

Emerson Units and Output Configuration

Most users set the primary output to mass flow in kg/h. The second output often carries density in g/cm3 or temperature in °C. A Modbus RS485 channel gives totalized mass, sensor diagnostics, and fault codes. This setup simplifies PLC and SCADA integration. Most engineers skip the density output during commissioning. Later they need it for concentration checks or interface detection.

When to Use Micro Motion ELITE Versus a Standard Coriolis Meter

Here is the thing. The ELITE is a high accuracy reference meter. Some plants need that for reactor feed control or final product density checks. In practice many batching and blending jobs run fine with a 0.2 percent mass flow accuracy. A paint manufacturer in Vietnam runs a DN15 meter for solvent batching at 600 kg/h. A desalination plant in Australia watches seawater feed at 180 m3/h on a DN100 meter. Both use standard Coriolis meters from Silver Instruments and save 30 to 40 percent compared with premium models.

Applications We See on Customer Sites

Oil and gas terminals use Coriolis meters for LPG and crude oil mass totalizing. Food plants measure syrup, chocolate, and CIP flow. Chemical plants inject additives by mass, not volume. Water plants monitor sludge density and return activated sludge flow. A chemical plant in Indonesia prints batching reports in kg for a resin with viscosity around 450 cP at 40 °C. Because the meter reads mass and density at the same time, it works in many industries.

How to Select the Right Meter

Send Silver Instruments your process data. Include fluid name, pressure in bar, temperature in °C, pipe size in DN, mass flow range in kg/h, and required accuracy. If you have an existing Emerson model number, include that too. We will match the process connection, output, and hazardous area approval.

FAQ

Q: Can Silver Instruments supply a direct replacement for Micro Motion ELITE?
A: Yes. Silver supplies compatible Coriolis meters with the same process connection, output, and hazardous area certification. Send us your existing model code and calibration report.

Q: What accuracy do we need for chemical batching?
A: For most chemical batching systems, 0.2 percent of rate is enough. High precision blending and reactor feed may need